Thermaflect™ Sleeve - Heat Shield Sleeve with Hook and Loop
A removable heat sleeve can be used prevent heat damage to components without disassembly.
- Reflects up to 90% of radiant heat (ASTM F1939 & Mil-C-24929A)
- Should NOT come in direct contact with heat source (needs an air gap)
- Prevents vapor lock, lowers air intake temperatures, protects wires
- Also available in a sewn seam
- Made in the USA
Thermaflect™ Sleeve is a lightweight heat reflective sleeve used to increase performance and keep things protected. Capable of reflecting up to 90% of radiant heat, this removable sleeve is great for protection without component disassembly. Capable of withstanding 1100-F of continuous radiant heat, and up to 500-F of direct contact this removable loom means business.
Air Gap + Air Flow = Reflectivity
With a 1 inch of airspace from the heat source and good airflow, Thermaflect™ Sleeve can drop temperatures drastically. An exceptional performance enhancing applications for this sleeve are air intake tubes/charge pipes preventing them from heating up. Because of it’s open seam and hook and loop fastening system, this also makes and excellent heat shield for wire harnesses.
Seal It for the Win
It is always preferred to have a sleeve tight on the fuel line or harness, it is not always necessary. Sometimes the inside diameter of the sleeve is a little to big for the component it is protecting. While a heat sleeve does not need to be tight over the component it is protecting it, the ends need to be. Not properly sealing the ends can allow heat to sneak in behind the sleeve in these instances. Using either the adjustment on the hook and loop seam, our HP Shrink™, or other method to secure the ends will give you the confidence this sleeve will protect your ride.
WARNING: This product can expose you to lead, a chemical known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov