Cobra Shield

Cobra Shield High Tech Carbon Fiber Look Heat Shield

  • Withstands 1100°F continuous, 2000°F intermittent

  • Revolutionary aluminized coating, won’t delaminate like foil cloths

  • Chemical and weather resistant coating

  • More rugged and abrasion resistant than laminated cloths

  • Reflects radiant heat way

  • Bulk rolls available

  • Made in the USA

Sku Description UPC
750002 0.014 in thk x 24 in x 24 in 819825013528
750004 0.014 in thk x 36 in x 58 in 819825013535
Cobra Heat Shield™ is a high-tech radiant heat barrier. It features a proprietary manufacturing process and chemical resistant coating: aluminum particles are bonded on a molecular level, as opposed to a laminate like with most aluminized radiant heat barriers. This makes Cobra Shield™ aluminum heat shielding material stronger and abrasion-resistant. It won’t delaminate when subjected to excessive moisture. In addition to the strong aluminized bond, a special coating makes Cobra Radiant Heat Barriers easy to clean and chemical- and corrosion-resistant. Cobra Shield™ is the ultimate heatshield for your transmission tunnel, hood, firewall, floorpan and so on. Cobra Shield™ withstands 1,100 degrees F continuous and 2,000 degrees F intermittent.


 Cobra Cloth Installation tips:

  • Be sure to use a 1" air-gap between Cobra Cloth and heat source for best results
  • Cobra Cloth is intended to be applied on the cold side of panel or component, i.e. it is not intended to direct contact with heat source

Required tools:

  • Heavy duty scissors or utility knife 
  • Carburetor cleaner or other degreaser
  • Pre-paint cleaner or other non residue cleaner
  • 3M Super Trim adhesive or other spray adhesive
  • Poster board, heavy paper - optional

PRO TIP - Use poster board or butcher paper to make a template. For surfaces with severe bends, it may be necessary to cut relief lines or wedges to get product to conform. Transfer template to Cobra Cloth and cut.

  1. Panel or component surface temperature should be at least 65°F, sticking onto anything colder may not allow adhesive to set up properly.
  2. Degrease and clean surface of any residual chemicals, using carburetor spray or other cleaner/degreaser.
  3. We strongly recommend rubbing the surface with a pre-paint cleaner or isopropyl alcohol (or other non-residue cleaner) after cleaning and degreasing.
  4. After Cobra Cloth has been cut, spray back of cloth and panel or component you are applying Cobra Cloth to.
  5. Allow adhesive to get tacky and apply cloth, start on one edge of panel or component and work out slowly to ensure no “bubbles” occur. Air bubbles will cause the material to not stick and fall off. Press firmly for 2 minutes.

MSDS | Specification Sheet | Brochure

Insulation type: Heat shield barrier, designed to shield radiant heat away

Not to be used directly on heat source.

Base material: Fiberglass, aluminum

Write Your Own Review
You're reviewing:Cobra Shield
Your Rating
To Top