Cool Foil Tape

Heat Shield Foil Tape

More Views

1000°F

538°C

CONTINUOUS

2000°F

1093°C

Intermittent

FEATURES:

  • Continuous operating reflective temperature of 1000°F

  • Capable of reducing up to 80% of radiant heat

  • Adhesive backing sticks to almost any clean surface

  • Helps shield fuel lines, brake lines, wire looms, and more from radiant heat

  • Bulk rolls and custom widths available, minimums apply

  • Made in the USA

Part No Description
340110 1 in x 10 ft heat shield foil tape
340210 2 in x 10 ft
340211 2 in x 150 ft

Cool Foil Tape™ is a lightweight & insulating thermal foil tape that reflects radiant heat away from wires, lines, cables and more on your car, 4x4, motorcycle or just about anything. This tape is an excellent way to insulate components without disassembly, or be used as a means to finish off other forms of thermal insulation to prevent fraying. Cool Foil Tape™ is very economical compared to other forms of heat protective aluminum tape, and it cuts easily and has a self-adhesive backing that sticks to most clean surfaces. Cool Foil Tape™ withstands 1,000 degrees F of continuous radiant heat and up to 400 degrees F direct contact.

 


 

  • Cuts easily with heavy scissors or utility knife
  • Cool Foil Tape is intended to be applied on the cold side of panel or component, i.e. it is not intended to direct contact with heat source
  1. Panel or component surface temperature should be at least 65°F, sticking onto anything colder may not allow adhesive to set up properly.
  2. Degrease and clean surface any residual dirt, grease, or chemicals, use carburetor spray or other cleaner/degreaser.
  3. We strongly recommend rubbing the surface with a pre-paint cleaner or isopropyl alcohol (or other non-residue cleaner) after cleaning and degreasing.
  4. Carefully peel the adhesive backing off the Cool Foil Tape stick and go!

MSDS | Specification Sheet | Brochure


 

More information coming soon!

More information coming soon!

heatshieldproducts (844) 723-2665