Industrial Heat Shield Panel - Thermaflect™ Shield
Industrial heat shield panels can be used to protect critical components and make plants operate more efficiently.
- Reflects up to 90% of radiant heat (ASTM F1939 & Mil-C-24929A)
- Mounts with grommets, rivets, screws or clamps
- Flexible, bends and conforms to almost any shape
- Perfect radiant heat shield for ovens
- Great for industrial applications
- OEM and custom manufacturing shields up to 50" wide
- Made in the USA
Thermaflect™ Shield is intended for redirect radiant heat to protect workers and improve the efficiency of industrial ovens. As the highest quality reflective industrial heat shield on the market, there is no better way to shield up to 90% of radiant heat. We use a 1/4 in thick Inferno Core (filament silica) inner pad sandwiched between heavy duty foil and bound together with a stainless steel mesh at the edges. By binding the edges with this mesh, we create greater flexibility and a more rugged product. This heat shield withstands 1100°F continuous radiant heat and 500°F of direct contact. All of these heat shields may be fastened with HP Power Anchors, Thermal-Tie, safety wire, screws, or rivets. We can even make custom shields and include mounting grommets!
WARNING: This product can expose you to chromium, a chemical known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
Thermaflect Shield can bet wrapped around a component and secured with our Thermal-Tie, clamp, or wire
Screw/rivet installation
- Thermaflect Shield may be secured to a panel using an adhesive or mechanical fasenters.
- Use large washer (fender washer) or large head rivets
- Pre-punch holes through Thermaflect Shield. This way when screing into shield, you reduce risk of screw grabbing insulation inside.
- Attach shield to panel
Spray adhesive installation
- Degrease and clean surface any residual dirt, grease, or chemicals, use carburetor spray or other cleaner/degreaser.
- We strongly recommend rubbing the surface with a pre-paint cleaner or isopropyl alcohol (or other non-residue cleaner) after cleaning and degreasing.
- Spray surface area and side of Thermaflect Shield with spray adhesive (something like 3M Super 77 or 3M super Trim adhesive)
- Let both surfaces get tacky
- Press Thermaflect Shield onto surface and hold for 2 minutes
- If you with to edge the surface of the Thermalfect shield use the Cool Foil Tape or Thermaflect Tape
Q. Can I put Thermaflect Shield directly on the exhaust?
A. No, Thermaflect Shield is a radiant heat barrier it is engineered to shield heat that is 1" away from the shield.
Q. Why don't you recommend a high temperature spray adhesive for Thermaflect Shield?
A. A high temperature spray adhesive would work just fine. Thermaflect Shield knocks heat down enough that is falls well within the temperature parameters of Super 77 or Super Trim adhesive spray
