Marine Fire Shield Sleeve

Marine Fire Shield Sleeve

More Views

500°F

260°C

CONTINUOUS

1000°F

538°C

Intermittent

FEATURES:

  • Continuous operating temperature of 500°F, 1000°F intermittent

  • Silicone layer can be cleaned and protects against abrasion

  • Helps to prevent vapor lock, protects wires from melting

  • Reduces and dissipates heat - great for engine rooms

  • Always wear safety glasses, dust mask, gloves and long sleeves are recommended when handling this product

  • Made in the USA

Part No Description
No options of this product are available.

Fire Shield Sleeve provides thermal and physical protection with its rugged silicone covering. Starting with braided shield sleeve fiberglass yarns in a flexible substrate; it is then coated with a high grade silicone rubber. This rugged silicone coating makes the Fire Shield Sleeve resistant to most chemicals including hydraulic fluids, oils, and fuels. The coating also makes it resistant to abrasion and fraying. This is the ideal engine room heat shield sleeve, perfect for bundling wires, protecting hydraulic lines, and more. In addition the rugged silicone coating makes this heat shield sleeve ideal for protecting welding lines and cables. Fire Shield Sleeve also insulates against energy loss in piping and hosing; protects employees from burns improving efficiency. This sleeve is designed to reduce and dissipate heat and works great in harsh environments exist that require heat shield insulation. HP Fire Armor Sleeving withstands 500°F continuous and brief intervals of 1000°F.

Install Exhaust Wrap


Required equipment: safety glasses, dust mask, gloves, scissors or utility knife

Pretty easy, just cut to length!

Pro Tip: Compress or “bunch” the sleeve length wise, and stretch the opening of the sleeve then slide over. It may also help to coat fitting or terminal with silicone or dry graphite spray before sliding over. To decrease the id of sleeve after it slides over fitting/terminal pull on both ends of the sleeve to stretch the length.

MSDS | Specification Sheet | Brochure | Brochure (Printer Friendly)


Insulation Type: Dissipates heat

AN SLEEVING CALCULATOR

Disclaimer:

The following conversion is a guide for AN hoses only. The conversion reflects the most common conversions for AN hose sizes, however there may be some variances with different manufactureres. Always double check by measuring the OD of your hose. Always verify the OD of your hose, you may use a caliper or sliding an open end wrench over the hose. If you are still unsure verify with the manufacturer of the hose as to their specific OD. By using this calculator you acknowledge this is a guide only and it is ultimately your responsibility to verify the correct OD of your AN line.

ENTER AN HOSE SIZE WITHOUT DASH:

:

RESULTS:

 

:

:

:

heatshieldproducts (844) 723-2665