Marine Heat Shield Sleeves

Marine Heat Shield Sleeves

More Views

1100°F

593°C

CONTINUOUS

2000°F

1093°C

Intermittent

FEATURES:

  • Continuous operating reflective temperature of 1100°F, 2000°F intermittent

  • Capable of reducing up to 90% of radiant heat

  • Helps to prevent vapor lock, lower air intake temperatures, protects wires from melting

  • Hook and loop seam allows installation without component assembly

  • Also available in a hook and loop seam

  • Larger diameters and rolls are available upon special request

  • Caution this material is electrically conductive; be sure to insulate any terminals that might come in contact with this product

  • Always wear safety glasses, dust mask, gloves and long sleeves are recommended when handling this product.

  • Made in the USA

Part No Description
HD27011 1/2 in x 10 ft Sewn
HD27012 1/2 in x 25 ft, sewn external hem
HD27021 3/4 in x 10 ft
HD27022 3/4 in x 25 ft sewn
HD27101 1 in x 10 ft, sewn
HD27102 1 in x 25 ft sewn
HD27151 1-1/2 in x 10 ft sewn
HD27152 1-1/2 in x 25 ft, sewn
HD27201 2 in x 10 ft, sewn
HD27202 2 in x 25 ft, sewn
HD27251 2-1/2 in x 10 ft, sewn
HD27252 2-1/2 in x 25 ft, sewn
HD27301 3 in x 10 ft, sewn
HD27302 3 in x 25 ft, sewn
HD27351 3-1/2 in x 10 ft, sewn
HD27352 3-1/2 in x 25 ft, sewn
HD27401 4 in x 10 ft, sewn
HD27402 4 in x 25 ft, sewn
HD27451 4-1/2 in x 10 ft, sewn
HD27452 4-1/2 in x 50 ft, sewn
HD27501 5 in x 10 ft, sewn
HD27504 5 in x 25 ft, sewn

Shield your wiring, lines, hoses, and from engine room heat. Thermaflect Sleeve acts as a thermal barrier capable of reflecting up to 90% of radiant heat away (requires minimum of 1 inch of airspace and good airflow). It weighs a fraction of what silicone coated sleeves do and it offers superior radiant high heat wire insulation. Thermaflect Sleeve withstands 1100°F of continuous radiant heat and 500°F direct heat. Also available in a hook and loop seam.

MSDS | Specification Sheet | Brochure | Brochure (printer friendly)


Insulation type: Thermal Barrier, designed to shield radiant heat

Base material: Fiberglass

Color: Silver/Chrome

AN SLEEVING CALCULATOR

Disclaimer:

The following conversion is a guide for AN hoses only. The conversion reflects the most common conversions for AN hose sizes, however there may be some variances with different manufacturer's. Always double check by measuring the OD of your hose. Always verify the OD of your hose, you may use a caliper or sliding an open end wrench over the hose. If you are still unsure verify with the manufacturer of the hose as to their specific OD. By using this calculator you acknowledge this is a guide only and it is ultimately your responsibility to verify the correct OD of your AN line.

ENTER AN HOSE SIZE WITHOUT DASH:

:

RESULTS:

 

:

:

:

heatshieldproducts (844) 723-2665