Marine HP Hose Sleeve

Marine HP Hose Sleeve

More Views

1200°F

649°C

CONTINUOUS

2000°F

1093°C

Intermittent

FEATURES:

  • Continuous operating temperature of 1200°F, 2000°F intermittent

  • Capable of reducing up to 60% of radiant heat

  • Helps to prevent vapor lock, protects wires from melting

  • Sleeving wall thickness is 1/16” thick

  • Made in the USA

Part No Description
240004 1-3/4 in id x 100 ft Roll

Shield marine hoses, radiator hoses, hydraulic hoses, and more from heat damage. Use HP Hose Sleeving to insulate air intake tubes from radiant heat lowering your intake temperatures and increasing horsepower on your marine vessel. Special coating allows this marine exhaust hose sleeving to reflect and dissipate heat. The special braid of sleeving allows it to have an expandable inside diameter from 1¾" to 2 3/8". Thermal Hose Sleeving is capable of withstanding 1200°F continuous. This marine exhaust hose sleeve may be fastened using Thermal-Tie™ or hose clamp.

MSDS | Specification Sheet | Brochure | Brochure (printer friendly)


Insulation type: Dissipates heat

Base material: Fiberglass

Color: Tan

AN SLEEVING CALCULATOR

Disclaimer:

The following conversion is a guide for AN hoses only. The conversion reflects the most common conversions for AN hose sizes, however there may be some variances with different manufacturer's. Always double check by measuring the OD of your hose. Always verify the OD of your hose, you may use a caliper or sliding an open end wrench over the hose. If you are still unsure verify with the manufacturer of the hose as to their specific OD. By using this calculator you acknowledge this is a guide only and it is ultimately your responsibility to verify the correct OD of your AN line.

ENTER AN HOSE SIZE WITHOUT DASH:

:

RESULTS:

 

:

:

:

heatshieldproducts (844) 723-2665