Moto Foil Heat Shield Tape

  • Continuous operating reflective temperature of 1000°F

  • Capable of reducing up to 80% of radiant heat

  • Adhesive backing sticks to almost any clean surface

  • Perfect for lining under tank heat shields!

  • Bulk rolls and custom widths available, minimums apply

  • Made in the USA

Sku Description UPC
341101 1 in x 10 ft heat shield foil tape 819825015294

This light weight thermal insulating tape reflects radiant heat away from wires, lines, cables, and more on your motorcycle. Thermal Insulated Tape is an excellent way to insulate components without disassembly, or use it as a means to finish off other forms of thermal insulation to prevent fraying. This foil tape is very economical compared to other forms of heat insulation tape, cuts easily, and has a self-adhesive backing that sticks to any clean surface. This reflective heat shield tape withstands 1000-degrees Fahrenheit of continuous radiant heat and up to 400-degrees Fahrenheit direct contact


  • Cuts easily with heavy scissors or utility knife
  • Cool Foil Tape is intended to be applied on the cold side of panel or component, i.e. it is not intended to direct contact with heat source
  1. Degrease and clean surface any residual dirt, grease, or chemicals, use carburetor spray or other cleaner/degreaser.
  2. We strongly recommend rubbing the surface with a pre-paint cleaner or isopropyl alcohol (or other non-residue cleaner) after cleaning and degreasing.
  3. Carefully peel the adhesive backing off the HP Sticky Shield, it may be necessary to use a utility knife or razor blade to properly start peeling from one corner
  4. Press the  Cool Foil Tape firmly onto the intake manifold, hold while pressing down for 2 minutes.
  5. If you are using Cool Foil Tape to seam or protect edges of Thermaflect Cloth or HP Heatshield Mat clean the top and side edges of the insulation with the pre-paint cleaner or isopropyl alcohol.
  6. Trim tape to fit the shield
  7. It is important to do one edge/seam at a time on the tape
  8. Peel adhesive backing off tape, press and firmly hold in place for 2 minutes

More information coming soon!

More information coming soon!

Write Your Own Review
You're reviewing:Moto Foil Heat Shield Tape
Your Rating
To Top