Heat Shield Tape

Heat Shield Tape

More Views

1100°F

593°C

CONTINUOUS

2000°F

1093°C

Intermittent

FEATURES:

  • Capable of reducing up to 90% of radiant heat

  • Adhesive backing sticks to almost any clean surface

  • Helps shield fuel lines, brake lines, wire looms, and more from radiant heat

  • Bulk rolls and custom widths available, minimums apply

  • Made in the USA

Part No Description
340001 1-1/2 in x 3 ft
340020 1-1/2 in x 20 ft heat shield tape
340250 2 in x 50 ft
340410 4 in x 10 ft heat shield tape
721150 0.032 th x 12 in x 50 ft Roll

Thermaflect Tape™ reflects up to 90 percent of radiant heat away from wires, lines, cables and hoses, protecting them from ambient heat, and it withstands 1,100 degrees F continuous radiant heat (requires minimum of 1 inch airspace) and 500 degrees F of direct contact. Thermaflect Tape™ insulates components without requiring disassembly for installation, or it can be used to hold other thermal-barrier products in place. Thermaflect heat shield tape can also be used as a quick solution to radiant heat-damage problems — use it at a track to control a hot spot. Durable cloth construction makes it last longer than similar products. Thermaflect Tape™ is easy to cut and install, thanks to our high-temperature self-adhesive backing that sticks to any clean surface. Thermaflect Tape™ rolls are available up to 150 feet long, with minimum roll sizes applying. Thermaflect Tape™ is a must-have for your shop or racetrack toolbox.

 



 

  • Cuts easily with heavy scissors or utility knife
  • Thermaflect Tape is intended to be applied on the cold side of panel or component, i.e. it is not intended to direct contact with heat source
  1. Panel or component surface temperature should be at least 65°F, sticking onto anything colder may not allow adhesive to set up properly.
  2. Degrease and clean surface any residual dirt, grease, or chemicals, use carburetor spray or other cleaner/degreaser.
  3. We strongly recommend rubbing the surface with a pre-paint cleaner or isopropyl alcohol (or other non-residue cleaner) after cleaning and degreasing.
  4. Carefully peel the adhesive backing off the Thermaflect Tape stick and go!

MSDS | Specification Sheet | Brochure


Insulator Type: Thermal Barrier, Shields Radiant Heat Way

No to be used directly on exhaust system

Color: Aluminum

Q. Can I use Thermaflect Tape on my exhaust?

A. No, Thermaflect Tape is a thermal barrier, it will not work directly on a heat source. Installing directly on an exhaust system may result in the adhesive backing catching on fire.

Use Heat Shield Tape on:

  • Wire loom
  • Air box 
  • Cold Air Intake
  • Intercooler pipe
  • Fuel lines
  • AC lines

heatshieldproducts (844) 723-2665