Header and Manifold Heat Shield - Header Armor
Exhaust manifold heat shield kit is easy to trim and wrap around headers
Exclusive BioCool technology – bio-soluble silica insulation
Compliant with most header manufacturer's warranties
Made in the USA
Exhaust manifold heat shield can reduce under hood temperatures up to 60 percent, lower air intake temperatures and create more horsepower. Header Armor™ keeps you cool at the track or on the street with the easiest to install and longest lasting heat shield blanket available for your headers Header Armor from Heatshield Products.
The abrasion-resistant Header Armor cuts effortlessly with heavy-duty scissors, making it simple to wrap around the headers. Removal of the headers is not necessary for installation on many vehicles. The exclusive BioCool™ insulation can withstand a continuous 1,800 degrees Fahrenheit with intermittent spikes of 2,200 degrees, and it lasts longer than other exhaust wraps. It is a bio-soluble high temperature insulation that offers little to no smoke after it has been installed.
In addition to being abrasion-resistant, Header Armor has an aluminum layer that rejects chemicals. Because it does not completely wrap the entire header, it is compliant with most header manufacturers’ warranties. Kits are available for single headers and a pair of headers, and all kits include a small spool of Inconel HP Tie Wire to secure this header heat shield in place. We also recommend using the 1/2 inch thick kits for forced induction and racing applications.
Wrapping headers with a high-efficiency heat blanket keeps heat in the exhaust system, moving it out of the engine compartment. This lowers under hood temperatures, helping with overall engine cooling and transferring less heat to the passenger compartment through the firewall. Header Armor also results in hotter and faster-flowing exhaust gases that create a scavenging effect to pull intake gases through the system quicker. This lowers intake temperatures further, resulting in more power.
Fly low, fast and cool with Header Armor from Heatshield Products!
If you are not going to cover the collector on the header, you must stop the Header Armor 6 inches from the collector. Heatshield Products Strongly recommends you cover one entire side of your header or manifold including the collector. Failure to do so will cause some portions to cool more quickly than others. This can result in separations at the welds on the collector.
Covering one entire side (collector included) of the header will ensure long header life and should remain in compliance with most manufacturer’s warranty policies.
Insulation Type: Insulator - Designed to be put directly on heat source to keep in