Fuel and Oil Line Heat Shield Sleeve - HP Builder's Kit
Continuous operating temperature of 1100°F, 2000°F intermittent
Capable of reducing up to 60% of radiant heat
Special weave that allows it to expand and contract over fittings
Helps to prevent vapor lock, protects wires from melting, shields oil and brake lines
Bulk rolls available
Made in the USA
HP Builder Fuel Line Insulation Kit
Cooler fuel lines with an old-school look -- what could be better? Introducing our HP Builder Kit for motorbikes. This moto and sportbike thermal sleeve set comes with four black fiberglass heat sleeves in three handy diameters:
- A 5/16-inch sleeve for small wire looms and brake lines.
- A 5/8”-inch sleeve for oil lines.
- A 1-1/4”-inch sleeve for radiator lines.
Heatshield Products’ HP Thermal Sleeving: Protect Your Lines for Better Performance
When you’re getting revved up on the racetrack and ready to jump ahead of the crowd, there’s nothing worse than being stopped by vapor lock. Our fuel line insulation kit prevents this problem by protecting your bike’s lines from radiant heat.
Made from a flexible fiberglass weave that expands and contracts over fittings and terminals, our HP moto thermal sleeve can dissipate temperatures up to 1100°F continuous and 2000°F intermittent while adding that classic aesthetic and hiding unsightly wires. With a 60% reduction in radiant heat, your wires are no longer at risk of melting or suffering irreversible heat damage from being too close to the motor or exhaust pipe.
Installing Your Heatshield Products HP Thermal Sleeving
You’ve bought your HP thermal sleeve kit—how do you install it? Wearing safety glasses, gloves, and an industrial dust mast, bunch or shrink the tubing over each component and secure the ends with our Thermal-Tie, hose clamps, exhaust wrap ties, or tie wire. For an OEM look you can do yourself, you can also seal the ends of the thermal sleeve with our Heatshield heat shrink tubing (thanks to Bryan Fuller of Fuller Hot Rods for this pro tip!)
Get Racetrack Ready with Heatshield Products
Whether you live on the track or prefer the road, our HP thermal sleeve provides an easy upgrade that will extend the life of your components. Want to know more about our premium American heat shields or ask about bulk buys? Give us a call directly and check out this Heatshield Products HP thermal sleeving by visiting a distributor today.
HP Builder's Kit Installation Tips
- To expand ID of sleeve, bunch or shrink the overall length of sleeve
- To decrease ID stretch overall length
- Secure ends of sleeve with Thermal-Tie, clamp, wire, or high temp electrical tape
PRO TIP - As provided by Bryan Fuller of Fuller Hot Rods, use some heat shrink tubing on the ends to give it an OEM look.
Q. Will my Builder Kit Burn?
A. No, HP Builder’s Kit is made from a noncombustible fiberglass, even if surrounding fluids combust, the sleeve will not burn, and whatever is inside it will not burn.
Q. How do I get the sleeve to expand over fittings and terminals?
A. Compress or “bunch” the sleeve length wise, and stretch the opening of the sleeve then slide over. It may also help to coat fitting or terminal with silicone or dry graphite spray before sliding over.