HP Starter Shield

HP Starter Shield

More Views








  • Prevents starter heat soak so you are not stranded

  • Easy installation, starter removal is not necessary

  • Made in the USA

Part No Description
500025 7 in x 21-1/4in
501000 7-3/4 in x 21-3/4 in
501010 3-1/2 in x 18 in

HP Starter Shield™ prevents starter failure caused by excessive heat exposure. Using an HP Starter Shield™ also protects the solenoid and starter from starter heat lock. Quality construction and design allow for easy installation: Simply wrap the HP Starter Shield™ around the starter and fasten with the built-in hook-and-loop fasteners. Starter removal is not necessary for most applications, and two different sizes are available, eliminating the need for trimming. Our HP Starter Shield™, part no. 500025, is recommended in applications where there is less than 1-inch air space between the starter and heat source.

*Installation tip: Face hook and loop seam in the opposite direction of the heat source

For Part # 501000 and 501010 only

 Starter Heat Shield Installation tips:

  • Face hook & loop seam opposite of heat source
  • 501000 and 501010 are conductive, be sure to insulation and wirer, terminals, or circuits that may come in contact with the shield
  • Starter removal is not necessary in most cases
  • If you don't have a 1" air gap between heat source and starter use part no. 500025

MSDS | Specification Sheet | Brochure

More information coming soon!

Use HP Starter Shield on:

  • Starter motor
  • Distributor

heatshieldproducts (844) 723-2665