Moto Sticky Shield

Stick On Heat Shield - UTV, Rzr, Side by Side and Kart

  • Capable of reflecting over 90% of radiant heat

  • Flexible, bends and conforms to almost any shape

  • Perfect for Side by Sides, UTVs, and ATVs

  • Adhesive backing sticks to almost any clean surface

  • Can be cleaned after installed

  • Made in the USA

Sku Description UPC
M18001 10 in x 11 in, Seat Pan sticky heat shield 819825015119
M18002 12 in x 23 in, UTV stick on heat shield 819825015126
M18003 23 in x 24 in, UTV stick on heat shield 819825015133
Is that side by side burning your backside? Look no further than our HP Sticky Shield to keep your cool on in your UTV or side by side. ATV Heat Shield has a 0.003-inch thick armor layer combined with dense fiberglass insulation and high strength adhesive backing. The armor layer protects this side by side heat shield from mud, water, snow, and other elements while the dense fiberglass handles the ATV heat shielding. Included edging tape seals the edges of the insulation, making this stick on heat shield capable of being cleaned without coming apart! This UTV fire wall and trunk heat shield is capable of reflecting up to 90 percent of radiant heat.

This product is designed to be stuck on the "cold side" of a body panel, with the aluminum side facing the heat source. Line that tunnel or firewall to drop interior temps. How about lining the underneath your trunk to prevent your beverages from getting too hot or prevent that extra fuel can from boiling. Now you can finally take your ATV or UTV, keep your cool, and clean it without worry.

Please note, this product ships folded or rolled to keep costs down. You may see bends in it when it is received, bends will become minimally visible after installation.

MSDS | Specification Sheet | Brochure | Brochure (printer friendly)

Insulation type: Heat shield barrier, designed to shield radiant heat away

Base material: Fiberglass, aluminum

Q. Do I need tin snips to cut HP Sticky Shield

A. No, Sticky shield is cut easily with a pair of heavy duty scissors or utility knife. Tin snips will actually struggle with cutting the insulation on the sticky shield.

Q. Why don't you recommend HP Sticky Shield for rough unfinished fiberglass or carbon?

A. Self adhesives are not capable of filling in the small gaps, valleys and indentations of unfinished non smooth surfaces. This significantly reduces the performance of the adhesive backing. Spray adhesives are more capable of filling in these surface imperfections.

Q. Can I screw HP Sticky Shield into place?

A. Yes you can, if you want to add a screw or rivet in addition to the adhesive backing it is okay to do so. We just recommend using a large head rivet or fender washer.

Write Your Own Review
You're reviewing:Moto Sticky Shield
Your Rating
To Top