Thermaflect™ Cloth - Lightweight Heat Shield

Features:

This light weight heat shield material out performs similar products that weigh twice as much and 3 times the thickness. Thermaflect Cloth reflects over 90% of radiant heat crushing the competition.

  • Reflects up to 90% of radiant heat (ASTM F1939 & Mil-C-24929A)
  • Should NOT come in direct contact with heat source (needs an air gap)
  • Adhesive sticks most clean surfaces
  • Helps shield fire walls, hoods, body panels, floor boards
  • Proudly made in the USA
1100°F 593℃ CONTINUOUS
2000°F 1093℃ Intermittent
Sku Description
710040 0.018 thk x 36 x 56 in
711002 0.018 thk x 24 x 24 in w/adh
711005 0.018 thk x 36 x 56 in w/adh

Thermaflect™ Cloth is a heat shield cloth with a high-quality, mirror-like finish compared to most other thermal reflective aluminized cloth mats, and weighs 40 percent less than comparable aluminized fiberglass cloth products. When used in applications when there is 1 inch of airspace and good airflow, Thermaflect heat shield cloth is capable of reflecting 90 percent of radiant heat. The mirror-like finish and lightweight construction will blow the gold vinyl sticker stuff away with its reflectivity. Use it as a heatshield under the hood on a fuel cell, on aluminum intercooler pipes or for the air-filter box, or turn your aftermarket intake into a real cold-air intake! This product withstands 1,100 degrees F of radiant heat (requires minimum of 1 inch of airspace) and up to 450 degrees F of direct heat. To install it, face the aluminized side toward the source of heat to shield heat away. Thermaflect heat shield cloth is available with a high-temperature peel-and stick adhesive that will adhere to almost any clean surface. It is not recommended for rough, unfinished fiberglass or carbon fiber.

WARNING: This product can expose you to lead, a chemical known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov

Q. Will the adhesive backed Thermaflect Cloth cloth stick to my rough unfinished fiberglass?

A. No, the peel and stick version of Thermaflect Cloth does not stick well to rough surfaces. You could use the non-adhesive version and use a spray adhesive like 3M Super Trim Adhesive or Super 77. The spray adhesives can fill in the surface inconsistencies better than peel-and-stick adhesives.

Write Your Own Review
You're reviewing:Thermaflect™ Cloth
Your Rating
Proposition 65 requires businesses to provide warnings to Californians about significant exposures to chemicals that cause cancer, birth defects or other reproductive harm. These chemicals can be in the products that Californians purchase, in their homes or workplaces, or that are released into the environment.