Industrial Metal Heat Shield Tape

Industrial Metal Heat Shield Tape

More Views

1100°F

593°C

CONTINUOUS

2000°F

1093°C

Intermittent

FEATURES:

  • Continuous operating reflective temperature of 1100°F, 2000°F intermittent

  • Reflect heat away

  • Also used to seal and repair Heatshield Armor and HP Sticky Shield

  • 0.003" thick

  • Made in the USA

Part No Description
179001 1 in x 39 in Roll
179002 2 in x 39 in Roll
179003 6 in x 18 in Roll

Tidy up your HP Sticky Shield with your Heatshield Armor Weld Tape for your industrial application. Weld tape can also be used to seal the seams on any Heatshield Armor installation on GenSet! The welding tape is not intended to be used to hold the Heatshield Armor in place, it is strictly used on cold side if insulation for cosmetic reasons. It can also be used to protect the ends of the exposed insulation of the HP Sticky Shield to further protect it from the elements and extend the product's life.  This electrical shielding tape can also be used to shield radiant heat from components. The heavy duty peel and stick adhesive will stick to any CLEAN surface.

 



 

  • Cuts easily with heavy scissors or utility knife
  • Heatshield Armor Weld Tape is intended to be applied on the cold side of panel or component, i.e. it is not intended to direct contact with heat source
  1. Degrease and clean surface any residual dirt, grease, or chemicals, use carburetor spray or other cleaner/degreaser.
  2. We strongly recommend rubbing the surface with a pre-paint cleaner or isopropyl alcohol (or other non-residue cleaner) after cleaning and degreasing.
  3. Carefully peel the adhesive backing off the Heatshield Armor Weld Tape.
  4. Press the  Heatshield Armor Weld Tape firmly onto surface.
  5. If you are using Heatshield Armor Weld Tape to seam Heatshield armor, clean the top and side edges of the Heatshield Armor with the pre-paint cleaner or isopropyl alcohol.
  6. Trim tape to fit the shield
  7. It is important to do one edge/seam at a time on the tape
  8. Peel adhesive backing off tape, press and firmly hold in place for 2 minutes

 

heatshieldproducts (844) 723-2665